Remove/Install Constant Velocity Joint Or Boot Of Splined Rear Axle Shaft - AR35.30-P-0662OLC

Model 213, 238

Fig 1: Rear Axle Shaft Constant Velocity Joint And Boot Components Location - Model 213

G13746229

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove rear axle shaft (37a)	Model 213.088/089/288/289	AR35.30-P-0621MNE
		Model 213 (except 213.088/089/288/289), 238 Because a repair is only possible on certain rear axle shafts (37a), the availability of a repair kit should be checked in the EPC beforehand!	AR35.30-P-0621OLC
2	Clamp rear axle shaft (37a) using protective jaws in vise
3	Remove clamp (37k)
4	Remove cup seal (37i) from inner joint ring (37c) or outer joint ring (37b)		AR35.30-P-0662-01OLC
		Filling capacity for joint housing	*BF35.30-P-1001-01G
5	Dismantle constant-velocity joint		AR35.30-P-0662-03OLC
6	Press off joint hub (37d) from rear axle shaft (37a)		AR35.30-P-0662-02OLC
	Shell halves (2 ea.) for pressing off and caulking the inner constant velocity joint		WF58.50-P-3530-01A
	Staking tool for securing joint hub on rear halfshaft		WF58.50-P-3530-07P
		Drift	Fig 2
7	Remove boot (37l) of opposite constant velocity joint	If necessary. Boot (37l) can be pulled off over the rear axle shaft (37a).
	Check
8	Check constant velocity joints for wear	If there are problems ↓ Replace rear axle shaft (37).	AR35.30-P-0662-03OLC
9	Install in the reverse order

REAR AXLE SHAFT, PLUGGED IN SHAFTS

Number	Designation			Model 213 Plugged in shafts	Model 238 Plugged in shafts
BF35.30-P-1001-01G	Filling capacity for joint housing	Ø82	g	80	80
		Ø95	g	100	100
		Ø102	g	120	120
		Ø106	g	130	130
		Ø112	g	140	140
		Ø116	g	150	150

Fig 2: Identifying Drift (116 589 15 15 00)

G07693803

Courtesy of MERCEDES-BENZ USA