Remove/Install Headliner - AR68.30-P-4300LWE

Model 213.0/1 

Shown on model 213.0 with code 413 (Panoramic sliding roof) and except code 811 (Advanced sound system) 

Courtesy of MERCEDES-BENZ USA

Shown on model 213.0 with code 811 (Advanced Sound System) 

Courtesy of MERCEDES-BENZ USA

Shown on model 213.0 with code 413 (Panoramic sliding roof) and except code 811 (Advanced sound system) 

Courtesy of MERCEDES-BENZ USA

Shown on model 213.0 with code 413 (Panoramic sliding roof) and except code 811 (Advanced sound system) 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Completely open sliding roof lining on sliding roof	Model 213.0/1 with code 414 (Sliding sunroof)
2	Completely open front roller sun blind and rear roller sun blind on panoramic roof	Model 213.0/1 with code 413 (Automatic panoramic sliding sunroof)
3	Completely open roller sun blind on rear window	Model 213.0/1 with code 540 (Electric sunblind for rear window)
4	Remove inside rearview mirror (A67)		AR68.40-P-0001LW
5	Remove sun visors (2)		AR68.60-P-5480NKB
6	Remove paneling from sliding roof frame	Model 213.0/1 with code 414 (Sliding sunroof)	AR77.20-P-0500LW
7	Remove A-pillar trim (3)		AR68.30-P-4050LW
8	Remove front grab handle (4) and rear grab handle (5)		AR68.30-P-4330NKB
9	Remove upper B-pillar paneling (6)		AR68.30-P-4700LW
10	Remove C-pillar paneling (7) and lay down to side with seat belt installed	Model 213.1	AR68.30-P-4491LWV
		Model 213.0	AR68.30-P-4490LWE
11	Disconnect electrical connection (13)	Model 213.0/1 with code 811 (Advanced sound system)
12	Slightly fold back foam material (9) and disconnect electrical connector (10)
13	Remove front seats		AR91.10-P-1000LW
14	Remove center console	Model 213.0 with transmission 716	AR68.20-P-2000LWA
		Model 213.0/1 with transmission 725	AR68.20-P-2000LWE
15	Remove edge guards (8) from bod flange in area of headliner (1)
16	Press catch hooks (arrows) together and unclip headliner (1) from front roof frame
17	Loosen headliner (1) on left and right on sliding roof frame	Model 213.0/1 with code 414 (Sliding sunroof)
		Long wedge	Fig 1
18	Detach headliner (1) on brackets (11) from roof bow	Helper required.
19	Push headliner (1) toward rear until guide hooks (12) are unhooked from rear roof frame and lay headliner (1) down into vehicle	Helper required.
20	Remove headliner (1) through right rear door cutout from vehicle as shown	Do not bend headliner (1) excessively. Otherwise the headliner (1) can kink and be damaged. Helper required.
21	Make sure that all of the soundproofing on the headliner (1) is properly attached and in good condition.	Model 213.0 with code 460 (Canada version) Model 213.0 with code 494 (US version) If the headliner (1) is reused. If complaint present ↓ Replace the affected soundproofing on the headliner (1).
22	Prepare new headliner (1) for installation	When replacing roof paneling (1).
			AR68.30-P-4305-16LWE
		Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide	*BR00.45-Z-1144-02A
23	Install in the reverse order

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA