Remove/Install Additional Fan For COMAND - AR82.85-P-0005GQ

Model 166 

Model 292 

Fig 1: COMAND Fan Motor Components Location - Model 166

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch on ignition and store transmitter key outside of transmission range (min. 2 m)
2.1	Remove glove compartment	Model 166 Model 292.### 1#	AR68.10-P-1400GQ
2.2	Remove/install lower section of dashboard	Model 292.### 2#	AR68.10-P-1505GQ
3	Turn filter towards right (arrow) and remove filter
4	Disconnect electrical connector of electrical line (4) from COMAND fan motor (M4/13)
5	Unscrew bolt (3)
6	Detach COMAND fan motor (M4/13) from instrument panel carrier
7	Slide air duct (5) towards rear and unclip from guide (6)	Correct engagement of air duct (5) in guide (6) must be ensured.
8	Install in the reverse order