Remove/Install Drive Cable For Panoramic Sunroof Roller Sun Blind - AR77.21-P-0230EW
MODEL 166, 212.0/1/2 with CODE (413) Panoramic glass roof with top sliding roof
Shown on model 212.0 on right side of vehicle
Shown on model 212.0 on right side of vehicle
Shown on model 212.0
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Remove front glass roof from panoramic sliding roof | Model 166 | AR77.21-P-0500GQ |
| Model 212.0/1/2 | AR77.21-P-0500EW | ||
| 2 | Remove roller sun blind from panoramic sliding roof | When moving front roller sun blind coupling (6), the driver (10) on the drive cable (9) is also moved. |
AR77.21-P-0215EW |
| 3 | Remove roller sun blind motor on panoramic sliding roof | Model 166 |
AR77.21-P-0490GQ |
| Model 212.0, 1, 2 | AR77.21-P-0490EW | ||
| 4 | Unscrew bolts (2) and remove reinforcement (3) | Rechargeable drill/screwdriver | |
| 5 | Unscrew bolts (4, 5) and lower guide rail (1) | Rechargeable drill/screwdriver |
|
| 6 | Pull rear roller sun blind (8) toward rear out of guide rail (1) | ||
| 7 | Remove rubber stop (7) | ||
| 8 | Pull drive cable (9) with front roller sun blind coupling (6) out of guide rail (1) | Observe installation position of drive cable (9) in guide rail (1) (arrows). |
Fig 1 |
| 9 | Install in the reverse order |