Remove/install tilting/sliding roof frame - AR77.20-P-3000GW
MODEL 463 (except 463.202) as of model year 2013/model refinement package 2012
| Removing | |||
| 1 | Remove tilting/sliding roof panel | AR77.20-P-1000GW | |
| 2 | Remove control cable | AR77.20-P-1400GW | |
| 3 | Remove headliner | AR68.30-P-4300GW | |
| 4 | Remove guide tube from tilting/sliding roof frame (1) | AR77.20-P-1410GW | |
| 5 | Remove water drain hoses (2) | ||
| 6 | Remove bolts (4) from tilting/sliding roof frame (1) | ||
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| 7 | Remove tilting/sliding roof frame (1) | ||
| Install | |||
| 8 | Insert left and right adjustment gauges into side guide (gate) and into groove in pop-up bracket (arrows) | ||
| Figure | |||
| Figure | |||
| 9 | Insert tilting/sliding roof frame (1) | ||
| 10 | Install tilting/sliding roof frame (1) | Both rear bolts (4) have a metric thread so that the frame is centered in the tilting/sliding roof cutout. |
|
| 11 | Install water drain hoses (2) | ||
| 12 | Install guide tube (3) on tilting/sliding roof frame (1) | ||
| 13 | Install headliner | AR68.30-P-4300GW | |
| 14 | Install control cable | AR77.20-P-1400GW | |
| 15 | Install tilting/sliding roof panel | AR77.20-P-1000GW | |
| 16 | Remove adjustment gauges (6) | Figure | |
| Figure | |||
| 17 | Carry out function check |