Remove/Install Side Supplemental Restraint System (SRS) Pressure Sensor - AR91.60-P-0760XG

Model 463 

as of model year 2019 

Shown on front door 

Fig 1: Side Supplemental Restraint System (SRS) Pressure Sensor Components Location - Model 463 As Of Model Year 2019 (Shown On Front Door)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical component parts to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Disconnect ground line from battery.		AR54.10-P-0003XG
2.1	Remove door lining at front door.	When removing the left front door pressure sensor (B 48/7) or the right front door pressure sensor (B 48/8).
			AR72.10-P-1000XG
2.2	Remove door lining at rear door.	When removing the left rear door pressure sensor (B 48/9) or the right rear door pressure sensor (B 48/10).	AR72.12-P-1010XG
3	Disconnect electrical connector (1).
4	Lift tab (arrow), turn pressure sensor (B 48/7, B 48/8, B48/9, B48/10) 90° counterclockwise and remove.
5	Install in reverse order.
	Check
6	Check Supplemental Restraint System (SRS) using vehicle diagnosis system.	When replacing the pressure sensor (B 48/7, B 48/8, B48/9, B48/10).
			AD00.00-P-2000-04B