Remove/Install Front SAM Control Unit - AR54.21-P-1254GW
Model 463
as of Model year 2013 up to Model year 2019 /Facelift 2012
Fig 1: Front SAM Control Unit Components Location - Model 463 As Of Model Year 2013 Up To Model Year 2019 /Facelift 2012
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Connect Star Diagnosis and perform commissioning of SAM control unit (N10) | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 2 | Switch off ignition | ||
| 3 | Remove center console (1) | Remove/install center console | AR68.20-P-2000GW |
| 4 | Remove front bracket (2) and retaining plates (3) | ||
| 5 | Pull air duct segment (4) to rear and remove | ||
| 6 | Disconnect electrical connectors from SAM control unit (N10) | ||
| 7 | Detach SAM control unit (N10) from holder and remove | ||
| 8 | Install in the reverse order |