Actuate Driving Lights, Basic Function - GF82.10-P-1013A
Model all (CAR)
Overview
This document contains the following information:
- General
- Actuate manual low beam
- Actuate automatic low beam
- Actuate high beam
General
Driving lights include all the light functions required for optimum illumination of the roadway:
- Low beam
- High beam
- Daytime running lamps
- Headlamp range control
- Cornering light (dynamic LED headlamps)
- Variable light distribution (dynamic LED headlamps)
- Automatic high beam (dynamic LED headlamps)
Vehicles with LED headlamps
The front lamp units are equipped with fan motors. Operation of the fan motors provides active ventilation of the front lamp units (thermal management).
The fan motors are switched on when low beam or high beam are switched on.
Actuate manual low beam
The low beam illuminates the roadway without dazzling other road users. Low beam headlamps are operated using the exterior lights switch.
Function requirement
- Circuit 15 ON
Operating principle
The exterior lighting control unit actuates the low beam in the front lamp units independently or their actuation is requested. This takes place depending on the version of the front lamp units (halogen headlamps or LED headlamps). Depending on the vehicle, the control unit for the exterior lighting is either the central signal acquisition and actuation module or the front signal acquisition and actuation module. The activated low beam is displayed on the instrument cluster.
Vehicles with halogen headlamps
The difference in light colors for the light sources means that the standing lights are switched off when low beam is on.
The front standing lights are not switched off in the following countries:
- Brazil
- Georgia
- Canada
- Korea
- Russia
- Ukraine
- USA
- Belarus
Actuate automatic low beam
The low beam is switched on or off depending on the ambient brightness or depending on the activities of the windshield wiper system. The ambient brightness is sensed by the light sensor in the rain and light sensor. The windshield wiper system control (dependent on vehicle either the central signal acquisition and actuation module or the front signal acquisition and actuation module) provides information on its activities.
The automatic low beam is purely a comfort function and it does not relieve the driver of the need to follow the operating instructions as prescribed by the road traffic regulations.
In the event of any light sensor failure, the low beam is not deactivated until the engine is switched off.
If the windshield wiper system is active for 20 s with a wipe cycle time of less than 6 s, the low beam is switched on. If there are no wipe cycles for 60 s, the low beam is switched off. The low beam is also switched off if the wiper activities are manually canceled. The low beam remains switched on when the wiper start suppression is active. If the wiper startup suppression function is canceled, the low beam remains switched on for a further 60 s.
With automatic low beam, the low beam and the standing lights are automatically switched on and off.
Function requirements
- Engine running or drivetrain operational or vehicle speed more than 3 km/h.
- Exterior lights switch in "AUTO" position
Operating principle
The exterior lighting control unit actuates the low beam in the front lamp units independently or their actuation is requested. This takes place depending on the version of the front lamp units (halogen headlamps or LED headlamps). Depending on the vehicle, the control unit for the exterior lighting is either the central signal acquisition and actuation module or the front signal acquisition and actuation module.
| Start of trip | Standing lamp | Low beam |
|---|---|---|
| Transmitter key not in the vehicle interior | Off | Off |
| Transmitter key in the vehicle interior | Off | Off |
| Circuit 15R on | On | Off |
| Circuit 15 ON | On after 2 s (halogen headlamp) | Off |
| Engine running or drivetrain operational or vehicle speed more than 3 km/h. | Off (country-specific for halogen headlamp) | On (high beams permissible) |
| End of trip | Standing lamp | Low beam |
| At the end of a trip, overlaps may occur between the automatic low beam and the headlamp switch-off delay (surround lighting). | ||
| Transmitter key in the vehicle interior (driver door closed) | On | Off |
| Transmitter key in the vehicle interior (driver door open) | Off | Off |
| Transmitter key not in the vehicle interior | Off | Off |
Actuate high beam
The high beam provides sufficient wide-area illumination of the roadway.
The high beam is operated using the combination switch.
If the combination switch is pulled back and held (headlamp flashing), the high beam is switched on for a maximum of 45 s. After this, a permanently pending request is interpreted as being defective and the high beam is switched off.
Function requirements
- For headlamp flasher function: Circuit 15R On
- For high beams function: low beam On
- Automatic high beam (dynamic LED headlamps) not active
Operating principle
The exterior lighting control unit actuates the high beam in the front lamp units independently or their actuation is requested. This takes place depending on the version of the front lamp units (halogen headlamps or LED headlamps). Depending on the vehicle, the control unit for the exterior lighting is either the central signal acquisition and actuation module or the front signal acquisition and actuation module. The activated high beam is displayed on the instrument cluster.
ULTRA RANGE Highbeam (vehicles with dynamic LED headlamp) In the ULTRA RANGE Highbeam, the range of the high beam is set to the legally permissible maximum. In comparison to halogen or static IFD headlamps, the middle range of the light performance is improved by more than 150 meters.
| Function schematics | |||
| Function schematic, actuate low beams | Model 118, 167, 177, 243, 247, 293Model 213, 238, 257, 290 as of model year 2021 | PE82.10-P-2504-97A | |
| Model 206, 223, 297 | PE82.10-P-2504-97C | ||
| Function schematic, actuate high beams | Model 118, 177, 243, 247 | PE82.10-P-2505-97A | |
| Model 167 Model 293 | PE82.10-P-2505-97B | ||
| Model 213, 238, 257, 290 as of model year 2021 | PE82.10-P-2505-97D | ||
| Model 206, 223, 297 | PE82.10-P-2505-97E | ||
| Subsystems | |||
| Actuate daytime running lights, basic function | GF82.10-P-1015A | ||
| Headlamp range control, basic function | Model all (CAR) except code 460 (Canada version) except code 494 (US version) |
GF82.10-P-1016A | |
| Actuate cornering lights, basic function | Model all (CAR) with code 316 (Digital IFD headlamps, SAF right-hand traffic) Model all (CAR) with code 317 (Digital IFD headlamps, left-hand traffic) Model all (CAR) with code 318 (Digital IFD headlamps, right-hand traffic) Model all (CAR) with code 640 (SAF dynamic LED headlamps, right-hand traffic) Model all (CAR) with code 641 (Dynamic IFD headlamps, left-hand traffic) Model all (CAR) with code 642 (Dynamic IFD headlamps, right-hand traffic) |
GF82.10-P-1017A | |
| Variable light distribution, basic function | Model all (CAR) with code 316 (Digital IFD headlamps, SAF right-hand traffic) Model all (CAR) with code 317 (Digital IFD headlamps, left-hand traffic) Model all (CAR) with code 318 (Digital LED headlamps, right-hand traffic) Model all (CAR) with code 641 (Dynamic LED headlamps, left-hand traffic) Model all (CAR) with code 642 (Dynamic LED headlamps, right-hand traffic) |
GF82.10-P-1019A | |
| Automatic high beams, basic function | Model all (CAR) with code 608 (Automatic high beam control (IHC)) Model all (CAR) with code 628 (INTELLIGENT HEADLAMP CONTROL PLUS (IHC+)) |
GF82.10-P-1020A | |
| LED headlamp thermal management, basic function | Model all (CAR) with code 316 (Digital LED headlamps, SAE right-hand traffic) Model all (CAR) with code 317 (Digital LED headlamps, left-hand traffic) Model all (CAR) with code 318 (Digital LED headlamps, right-hand traffic) Model all (CAR) with code 631 (Static LED headlamps, left-hand traffic) Model all (CAR) with code 632 (Headlamps, LED, static, right-side traffic) Model all (CAR) with code 640 (SAE dynamic LED headlamps, right-hand traffic) Model all (CAR) with code 641 (Dynamic LED headlamps, left-hand traffic) Model all (CAR) with code 642 (Dynamic LED headlamps, right-hand traffic) |
GF82.10-P-1030A | |
| Control units | |||
| Basic function of signal acquisition and actuation module | Model 118, 177, 243, 247 | GF54.21-P-9895A | |
| Basic function of signal acquisition and actuation module at front | Model 167, 206, 223, 293, 297 Model 213, 238, 257, 290 as of model year 2021 |
GF54.21-P-9896A | |
| Headlamp control unit, basic function | Model all (CAR) with code 316 (Digital LED headlamps, SAE right-hand traffic) Model all (CAR) with code 317 (Digital LED headlamps, left-hand traffic) Model all (CAR) with code 318 (Digital LED headlamps, right-hand traffic) Model all (CAR) with code 631 (Static LED headlamps, left-hand traffic) Model all (CAR) with code 632 (Headlamps, LED, static, right-side traffic) Model all (CAR) with code 640 (SAE dynamic LED headlamps, right-hand traffic) Model all (CAR) with code 641 (Dynamic LED headlamps, left-hand traffic) Model all (CAR) with code 642 (Dynamic LED headlamps, right-hand traffic) |
GF82.10-P-9890A | |
| LED matrix control unit, basic function | Model 167, 223, 293 with code 640 (SAE dynamic LED headlamps, right-hand traffic) Model 167, 223, 293 with code 641 (Dynamic LED headlamps, left-hand traffic) Model 167, 223, 293 with code 642 (Dynamic LED headlamps, right-hand traffic) Model 213, 238, 257, 290 as of model year 2021 with code 640 (SAE dynamic LED headlamps, right-hand traffic) Model 213, 238, 257, 290 as of model year 2021 with code 641 (Dynamic LED headlamps, left-hand traffic) Model 213, 238, 257, 290 as of model year 2021 with code 642 (Dynamic LED headlamps, right-hand traffic) Model all (CAR) with code 316 (Digital LED headlamps, SAE right-hand traffic) Model all (CAR) with code 317 (Digital LED headlamps, left-hand traffic) Model all (CAR) with code 318 (Digital LED headlamps, right-hand traffic) |
GF82.10-P-9891A | |
| Components | |||
| Rain and light sensor, basic function | GF54.21-P-2005A | ||
| Front lamp unit, basic function | GF82.10-P-2000A | ||
| Rear lamp unit, basic function | GF82.10-P-2004A | ||
| Exterior lights switch, basic function | GF82.10-P-2022A |