Remove/install telescoping nozzle for headlamp cleaning system - AR82.15-P-6100CW
MODEL 204.0/2/3, 207, 212 with CODE (600) Headlamp cleaning system
Shown on model 204 at right side of vehicle
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Lift vehicle on lifting platform. | ||
| 2.1 | Unfasten washer fluid reservoir of windshield washer system and push to side with lines connected | AR82.35-P-6000CW | |
| 2.2 | Detach front section of fender liner in right front fender far enough until the telescopic nozzle (1) can be removed | ||
| 2.3 | Remove front bumper | AR88.20-P-2000EW | |
| 3 | Unclip air filter of stationary heater unit (A6) and press to one side | ||
| 4 | Disconnect washing water hose (6) with clamp | Fig 2 | |
| 5 | Detach hose coupling (7) with washer fluid hose (6) from telescopic nozzle (1) | ||
| 6 | Open flap of headlamp cleaning system in front bumper | ||
| 7 | Unscrew bolt (2) | ||
| 8 | Release catch hook (3) and slide left and right telescopic nozzles (1) to the rear | ||
| 9 | Remove telescopic nozzle (1) | ||
| 10 | Install in the reverse order | ||
| 11 | Check spray nozzle setting of headlamp cleaning system, adjust if necessary | Model 204 | AP82.30-P-8252CW |
| Model 207, 212 | AP82.30-P-8252EW |