Prepare Bottom Rear Center Section For Installation - Ar64.20-P-1000-07LWT

Model 213.2 

Courtesy of MERCEDES-BENZ USA

1. Grind mating surfaces on rear center section (1) down to bare metal in crosshatched areas.

   Sand down spot weld flanges to bare metal on both sides.

2. Remove grinding dust.
3. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA

4. Apply 2-component adhesive for reinforcement on structural foam parts (3, 4).
5. Insert structural foam parts (3, 4) into rear center section (1).