Prepare Firewall Half For Installation - Ar62.25-P-1110-02LWE

Model 213 

Model 238 

Model 253 

Model 293 

The next steps are shown on the left side of the vehicle on model 213 and must be performed in the same way on the right side of the vehicle in the event of damage.

1. Grind mating surfaces on firewall (3) down to bare metal in crosshatched areas.

   Courtesy of MERCEDES-BENZ USA

2. Grind mating surfaces on firewall (3) down to bare metal in crosshatched areas.
3. Remove grinding dust.

   Observe pretreatment of bonding surfaces.

   Courtesy of MERCEDES-BENZ USA

4. Mark separating point on firewall crossmember (5) and cut (area K).

   Transfer separation point from vehicle.

   If the connection is to be crimped, observe overlap of 10 mm.

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

5. Cut out spot welds on firewall crossmember (5) (areas L and L₁ ).
6. Heat firewall crossmember (5) in crosshatched area and remove section from firewall crossmember (5).

   Cross-hatched area is bonded.

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

7. Grind mating surfaces on firewall crossmember (5) down to bare metal in crosshatched areas.

   Courtesy of MERCEDES-BENZ USA

8. Grind mating surfaces on firewall crossmember (5) down to bare metal in crosshatched areas.

   Observe pretreatment of bonding surfaces.

9. Remove grinding dust.
10. Grind mating surfaces on pedal bowl (4) down to bare metal in crosshatched areas.
11. Remove grinding dust.

    Observe pretreatment of bonding surfaces.

    Pedal assembly cup (4), inside 

    Courtesy of MERCEDES-BENZ USA