Remove/Install Trunk Lid Lock - AR72.20-P-1022LW

Model 205.2 

Model 213.2 

Model 253 

Model 293 

Fig 1: Trunk Lid Lock Components Location - Model 213.2 (Shown On Model 205.2 With Code 890)

Courtesy of MERCEDES-BENZ USA

Shown on model 205.2 with Code 890 (EASY-PACK liftgate) 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove center liftgate trim (2).		AR72.20-P-6618LWS
2	Disconnect electrical connector (3).
3	Remove vibration damper.	Model 293	AR72.20-P-1025EQ
4	Remove screws/bolts (4).	Screw/bolt, door lock to liftgate	*BA72.20-P-1004-02N
5	Move trunk lid/liftgate latch (A85/5) out of liftgate (1).
6	Remove cable (5) from the trunk lid/liftgate latch (A85/5).	Model 205.2, 213.2, 253, 293 with Code 890 (EASY-PACK-tailgate)
7	Install in the reverse order.