(Remove/Install C-Pillar Trim Sections - AR68.30-P-4491LWV)

Model 213.1 

Courtesy of MERCEDES-BENZ USA

Shown with code 540 (Electric roller sun blind for rear window) and code 297 (Roller sun blinds in rear doors) 

Courtesy of MERCEDES-BENZ USA

Shown with code 540 (Electric roller sun blind for rear window) and code 297 (Roller sun blinds in rear doors) 

Courtesy of MERCEDES-BENZ USA

Shown with code 540 (Electric roller sun blind for rear window) and code 297 (Roller sun blinds in rear doors) 

	Remove/install
1	Remove side paneling (1)		AR68.30-P-4780LWE
2	Remove bolt (5) and remove belt end fitting	Model 213.1 except code 223 (Electrically adjustable rear bench seat)
		Bolt, rear belt end fitting	*BA91.40-P-1005-01U
3	Loosen edge guard in area of inner C-pillar paneling (2)
4	Unclip inner C-pillar paneling (2) and allow to hang down on seat belt	Model 213.1 with code 297 (Roller sun blinds in rear doors) Installation:  Ensure that handle (4.1) of roller sun blind is not pinched and is freely accessible after clipping in.
5	Loosen belt guide (2.1) from inner C-pillar paneling (2)
6	Remove connector (2.2)
7	Remove belt guide (2.1) from seatbelt
8	Remove inner C-pillar paneling (2) from seat belt
9	Unclip rear C-pillar paneling (3) at top and remove	Model 213.1 with code 540 (Electric sunblind for rear window) Installation:  Ensure that guide pin is seated correctly on roller sun blind (arrow B) in guide (arrow A). : Ensure that rear C-pillar paneling (3) is seated correctly in brackets (arrows C).
10	Unscrew nuts (6)	Carefully press headliner to side in area of front nut (6). Otherwise the headliner can be damaged or soiled.
11	Unclip outer C-pillar paneling (4)
12	Remove outer C-pillar paneling (4) and guide out at rear below windowbag (7)	Carefully guide outer C-pillar paneling (4) below windowbag (7). Otherwise the windowbag (7) can be damaged.
13	Install in the reverse order