Retrofit Reversing Camera - AN54.65-P-0030ELS

MODEL 218.3 (except 218.374/375/376/392) as of 7/1/14 

as of year 2014 

with CODE 512 (COMAND APS with DVD changer) 

except CODE 460 (Canada version) 

except CODE 494 (US version) 

except CODE 498 (Japanese version) 

with CODE 527 (COMAND APS with single DVD drive (with navigation)) 

except CODE 460 (Canada version) 

except CODE 494 (US version) 

except CODE 498 (Japanese version) 

Courtesy of MERCEDES-BENZ USA

Shown on model 218.3## 1# 

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove
1	Remove passenger seat		AR91.10-P-1000CW
2	Remove COMAND controller unit		AR82.60-P-7502EW
3	Remove center console		AR68.20-P-2000EL
4	Remove front and rear passenger-side door sill
5	Remove B-pillar trim on front passenger side
6	Fold passenger-side floor covering in rear to one side
7.1	Remove side bolster of passenger-side backrest in rear	Model 218.3 with code 287 (Folding rear seat backrests)	AR91.12-P-1710CW
7.2	Remove backrest in rear	Model 218.3 except code 287 (Folding rear seat backrests)	AR91.12-P-1620CW
8	Remove passenger-side side trim (1) in rear
9	Remove passenger-side side trim in trunk		AR68.30-P-4600EL
10	Remove handle strip from trunk lid	Remove trunk lid cover completely. Removed trunk lid handle strip is no longer required.	AR88.50-P-5062EL
11	Remove passenger-side trunk lid hinge trim
	Install
12	Retrofit wiring harness for reversing camera (B84/3)		AN54.65-P-0030-03ELS
		Right rear wheel arch ground point	*BA00.19-P-1008-01D
		Wiring harness repair kit, basic	Figure
		New passenger car wiring harness repair kit	Figure
13	Install remaining parts
	Update Vehicle Documentation (VeDoc)
14	Enter special equipment in on-line vehicle data card	Code 218 (Reversing camera)
15	Attach "Reversing camera retrofitted as per AN54.65-P-0030ELS" under field organization text for design group 54 and design group 88
16	Connect diagnostic system and select vehicle using vehicle identification number (VIN)		AD00.00-P-2000-04A
17	Carry out variant coding using software calibration number (SCN)	Central gateway (CGW) Front SAM with fuse and relay module COMAND control unit
18	Disconnect diagnostic system		AD00.00-P-2000-04A
	Check
19	Perform function test	See Owner's Manual.

Fig 1: Identifying New Passenger Car Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA