Remove/Install Trim At C-Pillar - AR68.30-P-4490CLW

Model 205.3 

Shown on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove rear passenger compartment side trim panel		AR68.30-P-4780CLW
2	Unscrew bolt (2)	Bolt, rear belt end fitting	*BA91.40-P-1005-01U
3	Unclip cover (3)	Retaining clip remains in C-pillar paneling (1). Clip remover	Fig 1
4	Detach C-pillar paneling (1) from C-pillar, slightly tilt toward center of vehicle and then move out toward front	Carefully remove C-pillar paneling (1). Otherwise roof paneling can be damaged. Installation:  Insert cover (3) into retaining clips on C-pillar paneling (1). Clip in C-pillar paneling (1) completely preassembled. Ensure that C-pillar paneling (1) is seated correctly.
5	Guide seat belt (4) through C-pillar paneling (1)
6	Install in the reverse order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 205.3
BA91.40-P-1005-01U	Bolt, rear belt end fitting	Nm	35

Fig 1: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA