Remove/install headlamp range adjustment front axle sensor - AR82.10-P-4083NKB
MODEL 117, 156, 176, 242, 246 as of model year 2016 with CODE 459 (Steel suspension with adjustable damping)
MODEL 117, 156, 176, 242, 246 up to model year 2015 with CODE 614 (Bi-xenon headlamps)
MODEL 117, 156, 176, 242, 246 up to model year 2015 with CODE 615 (Bi-xenon headlamps with active light function)
MODEL 117, 156, 176, 242, 246 up to model year 2015 with CODE 618 (Bi-xenon headlamps)
MODEL 117, 156, 176, 242, 246 up to model year 2015 with CODE 621 (Intelligent Light System (left-hand traffic))
MODEL 117, 156, 176, 242, 246 up to model year 2015 with CODE 622 (Intelligent Light System)
Fig 1: Identifying Headlamp Range Adjustment Front Axle Sensor Remove/Install Components - Shown On Model 246
Shown on MODEL 246
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Raise vehicle with vehicle lift | AR00.60-P-1000AK | |
| 2 | Disconnect electrical connector (2) | ||
| 3 | Unscrew bolt (4) | ||
| 4 | Unhook deflector (3) | ||
| 5 | Unhook front axle level sensor (B222) with bracket facing up out of auxiliary frame and remove | ||
| 6 | Unscrew screws (5) and remove bracket | When replacing the front axle level sensor (B22/2). | |
| 7 | Unclip deflector (3) at front axle level sensor (B22/2) | When replacing the front axle level sensor (B22/2). | |
| 8 | Install in the reverse order | ||
| 9 | Connect diagnostic system, read out fault memory and set zero position of front lamp units | ||
| AD00.00-P-2000-04A | |||
| 10 | Check headlamp setting and correct if necessary | ||
| AP82.10-P-8260GI |