Install new stabilizer bar pivot bushing - AR32.20-P-0310RK
MODEL 231 except CODE 487 (Active Body Control (ABC))
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | |||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | |||
| Remove/install | ||||
| 1 | Detach front wheel and tire assembly | |||
| AP40.10-P-4050EW | ||||
| 2 | Remove track rod (4) from steering knuckle (3). | AR46.40-P-0200EW | ||
| *BA46.40-P-1001-01E | ||||
| 3 | Unscrew nut (7), detach torsion bar link rod (6) from torsion bar pivot bushing (5) and swing vertically to one side | *BA32.20-P-1001-02H | ||
| 4 | Remove boot (2) and wire fasteners of torsion bar pivot bushing (5) | Otherwise the special tool will be damaged by excessive force. |
||
| 5 | Press stabilizer bar pivot bushing (5) out of spring control arm (1) | AR32.20-P-0310-01M | ||
| Fig 3 | ||||
| Fig 2 | ||||
| 6 | Install in the reverse order | |||
FRONT AXLE TORSION BAR
| Number | Designation | Model 231 | |
|---|---|---|---|
| BA32.20-P-1001-02H | Nut, torsion bar linkage to spring control arm | Nm | 130 |
TIE ROD
| Number | Designation | Model 231 | ||
|---|---|---|---|---|
| BA46.40-P-1001-01E |
Self-locking nut, tie rod to steering knuckle |
Stage 1 | Nm | 90 |
| Stage 2 | ∠° | 90 | ||