Remove/install track rod - AR46.40-P-0200EW
MODEL 166, 212, 218, 231
Shown on model 212 with hydraulic steering
| Remove/install | |||
| 1 | Detach front wheel and tire assembly | ||
| AP40.10-P-4050EW | |||
| 2 | Counterhold tie rod (10) and loosen jam nut (10f) | MODEL 166 |
*BA46.40-P-1001-01K |
MODEL 212, 218 |
*BA46.40-P-1002-01N | ||
MODEL 231 |
*BA46.40-P-1002-01E | ||
| 3 | Detach tie rod (10) from steering knuckle | Always counterhold ball head, do not use an impact wrench/driver! | |
| MODEL 212, 218 | AR46.40-P-0200-02CW | ||
MODEL 166 |
*BA46.40-P-1002-01K | ||
MODEL 212, 218 |
*BA46.40-P-1001-01N | ||
MODEL 231 |
*BA46.40-P-1001-01E | ||
Puller |
Fig 3 | ||
Puller |
Fig 5 | ||
Press |
Fig 2 | ||
Thrust piece |
Fig 4 | ||
| 4 | Unscrew tie rod (10) from inner tie rod (12) | ||
| 5 | Install in the reverse order | ||
| 6 | Perform wheel alignment check | MODEL 166 | AR40.20-P-0200GQ |
| MODEL 212, 218 | AR40.20-P-0200EW | ||
| MODEL 231 without CODE 990 (AMG vehicles) |
AR40.20-P-0200R |
TIE ROD
| Number | Designation | MODEL 166 | ||
|---|---|---|---|---|
| BA46.40-P-1002-01K | Self-locking nut, tie rod to steering knuckle | Stage 1 | Nm | 90 |
| Stage 2 | ∠° | 90 | ||
TIE ROD
| Number | Designation | MODEL 231 | ||
|---|---|---|---|---|
| BA46.40-P-1001-01E | Self-locking nut, tie rod to steering knuckle | Stage 1 | Nm | 90 |
| Stage 2 | ∠° | 90 | ||
TIE ROD
| Number | Designation | MODEL 212 | MODEL 218 | ||
|---|---|---|---|---|---|
| BA46.40-P-1001-01N | Self-locking nut, tie rod to steering knuckle | Stage 1 | Nm | 50 | 50 |
| Stage 2 | ∠° | 90 | 90 | ||
TIE ROD
| Number | Designation | MODEL 212 | MODEL 218 | |
|---|---|---|---|---|
| BA46.40-P-1002-01N | Jam nut, tie rod to inner tie rod | Nm | 65 | 65 |
TIE ROD
| Number | Designation | MODEL 231 | |
|---|---|---|---|
| BA46.40-P-1002-01E | Lock nut, tie rod to inner tie rod | Nm | 65 |
TIE ROD
| Number | Designation | MODEL 166 | |
|---|---|---|---|
| BA46.40-P-1001-01K | Clamping nut, tie rod to inner tie rod | Nm | 77 |