LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2016 >> S600 >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System - Body - 222 Chassis >> Testing & Repair >> Remove/install headlamp unit - AR82.10-P-4730LF

Remove/install headlamp unit - AR82.10-P-4730LF

MODEL 222 

Fig 1: Headlamp Unit Remove/Install Components
G11133068NOTESREMOVINGINSTALLINGREFER TO SELF-DIAGNOSTIC SYSTEMSINSTALLATION IMPORTANTNOTESREFER TO MAINTENANCECourtesy of MERCEDES-BENZ USA
NOTES Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Carry out initial startup of left front lamp unit (E1) or right front lamp unit (E2) When replacing the left front lamp unit (E1) or the right front lamp unit (E2).  
REFER TO SELF-DIAGNOSTIC SYSTEMS Connect STAR DIAGNOSIS and read out fault memory INSTALLATION IMPORTANT Note Data Matrix code on the left front lamp unit (E1) or right front lamp unit (E2). AD00.00-P-2000-04B
2 Switch off ignition and remove transmitter key or KEYLESS-GO start/stop button from electronic ignition lock control unit    
3.1 Remove radiator grille and detach bumper in area of left front lamp unit (E1) or right front lamp unit (E2) When removing left front lamp unit (E1) or right front lamp unit (E2). AR88.20-P-2000LF
3.2 Remove front bumper When removing left front lamp unit (E1) and right front lamp unit (E2). AR88.20-P-2000LF
4 Remove screws (1, 2, 3)    
5 Remove screw/bolt (arrow A) MODEL 222
with CODE 640 (Headlamps, LED, dynamic, SAE, right-side traffic)
MODEL 222
with CODE 641 (Headlamps, LED, dynamic, left-side traffic)
MODEL 222
with CODE 642 (Headlamps, LED, dynamic, right-side traffic)
 
6 Remove left front lamp unit (E1) or right front lamp unit (E2) until electrical connector at left front lamp unit (E1) or right front lamp unit (E2) is accessible NOTES
Carefully remove left front lamp unit (E1) or right front lamp unit (E2).
Left front lamp unit (E1) or right front lamp unit (E2) may be damaged by the fender.
 
7 Disconnect electrical connector from left front lamp unit (E1) or right front lamp unit (E2)    
8 Remove left front lamp unit (E1) or right front lamp unit (E2)    
9 Remove left front actuation module, LED exterior lighting or right front actuation module, LED exterior lighting MODEL 222
with CODE 640 (Headlamps, LED, dynamic, SAE, right-side traffic)
MODEL 222
with CODE 641 (Headlamps, LED, dynamic, left-side traffic)
MODEL 222
with CODE 642 (Headlamps, LED, dynamic, right-side traffic)
When replacing the left front lamp unit (E1) or the right front lamp unit (E2).
AR82.10-P-4650LF 
10 Remove left headlamp control unit or right headlamp control unit When replacing the left front lamp unit (E1) or the right front lamp unit (E2). AR82.10-P-4660LF 
11 Install in the reverse order    
12 Check headlamp adjustment    
REFER TO MAINTENANCE Check headlamp adjustment   AP82.10-P-8261A