Remove/install driving lights actuation module - AR82.10-P-4650LF

MODEL 217 

MODEL 222 

with CODE 640 (Headlamps, LED, dynamic, SAE, right-side traffic) 

MODEL 222 

with CODE 641 (Headlamps, LED, dynamic, left-side traffic) 

MODEL 222 

with CODE 642 (Headlamps, LED, dynamic, right-side traffic) 

Shown on MODEL 222.004 

Fig 1: Driving Lights Actuation Module Remove/Install Components - Shown On Model 222.004

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Carry out initial startup of left front actuation module, LED exterior lighting (E1n7) or right front actuation module, LED exterior lighting (E2n7)	When replacing the left front actuation module, LED exterior lighting (E1n7) or right front actuation module, LED exterior lighting (E2n7).
		Note Data Matrix code on the left front lamp unit (E1) or right front lamp unit (E2).	AD00.00-P-2000-04B
2	Remove left front lamp unit (E1) or right front lamp unit (E2)	MODEL 217	AR82.10-P-4730LC
		Model 222	AR82.10-P-4730LF
3	Remove screws/bolts (1) on left front actuation module, LED exterior lighting (E1n7) or right front actuation module, LED exterior lighting (E2n7)
4	Pull out left front actuation module, LED exterior lighting (E1n7) or right front actuation module, LED exterior lighting (E2n7) until electrical connectors (2, 3) can be disconnected	Ensure that seal (4) is seated correctly.
5	Disconnect electrical connectors (2, 3) and remove left front actuation module, LED exterior lighting (E1n7) or right front actuation module, LED exterior lighting (E2n7)
6	Install in the reverse order