Remove/install radiator grille - AR88.40-P-4001LF
MODEL 222
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Open engine hood | ||
| 2 | Remove screws (10) | ||
| 3 | Tilt radiator grille (9) at top toward front and release catches (arrow A) | ||
| 4 | Expose electrical connector on 360° camera at front and disconnect | Model 222 with code 501 (360° camera) |
AR54.30-P-3001LF |
| 5 | Remove radiator trim (9) | ||
| Engine hood to radiator trim | *BE60.00-P-1005-01BA | ||
| Protrusion of radiator trim/engine hood | *BE60.00-P-1006-01BA | ||
| Figure | |||
| 6 | Install in the reverse order | ||
| 7 | Calibrate front 360° camera using the diagnostic system | Model 222 with code 501 (360° camera) |
|
| AD00.00-P-2000-04B |
CHECK VALUES FOR GAP DIMENSIONS
| Number | Designation | Model 222 | ||
|---|---|---|---|---|
| BE60.00-P-1005-01BA | Engine hood to radiator trim | Dimension "C" | mm | 3, 5 (±1) |
| For picture, see | AR60.00-P-0700-01LF | |||
CHECK VALUES FOR GAP DIMENSIONS
| Number | Designation | Model 222 | ||
|---|---|---|---|---|
| BE60.00-P-1006-01BA | Protrusion of radiator trim/engine hood | Dimension "C" | mm | 1 (±1) |
| For picture, see | AR60.00-P-0700-01LF | |||