Remove/Install Valve Support Of Active Roll Stabilization - AR32.34-P-5030GQA
MODEL 166 with CODE (468) ACTIVE CURVE SYSTEM Front axle valve support
| Remove/install | |||
| Risk of injury to skin or eyes caused by hydraulic fluid spraying out under high pressure. Risk of poisoning caused by swallowing hydraulic fluid | Depressurize hydraulic system completely before starting any work on system. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on active roll stabilization | AH32.34-P-0001-01A | ||
| 1 | Switch off ignition | ||
| 2 | Remove underfloor paneling concerned | AR61.30-P-1001GQ | |
| 3 | Detach lines (1) from valve support (2) | AR32.00-P-0001-01A | |
| *BA32.34-P-1008-01A | |||
| Figure | |||
| Cleaner from package | *BR00.45-Z-1028-04A | ||
| 4 | Remove bolts (2s) and lower valve support (2) | *BA32.34-P-1002-01A | |
| 5 | Mark, release and disconnect electrical connectors (3) | ||
| 6 | Remove valve support (2) | ||
| 7 | Detach bracket from valve support (2) and front axle carrier | If necessary | |
| *BA32.34-P-1001-01A | |||
| *BA32.34-P-1003-01A | |||
| Checking | |||
| 8 | Check all rubber mounts of valve support (2) | ||
| 9 | Install in the reverse order | ||
| 10 | Fill and bleed ACTIVE CURVE SYSTEM | AR32.34-P-0021GQ |
ACTIVE ROLL STABILIZATION
| Number | Designation | Model 166 | |
|---|---|---|---|
| BA32.34-P-1001-01A | Bolt, bracket to front axle valve block | Nm | 8 |
| BA32.34-P-1002-01A | Bolt, valve support to front axle | Nm | 20 |
| BA32.34-P-1003-01A | Bolt, mounting plate to front axle valve support | Nm | 20 |
| BA32.34-P-1008-01A | Bolt, oil line to valve block on front axle/rear axle | Nm | 20 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1028-04A | Cleaner from package | Adolf Wurth GmbH & Co. KG |