Check Toe-Out Angle - AR40.20-P-0325XG

Model 463 

as of model year 2019 

	Check
1	Check toe on front axle, adjust if necessary.	See "Perform Wheel Alignment Check". ↓ Perform wheel alignment measurement.	AR40.20-P-0200XG
2	Check toe-out angle.	To check the steering geometry, measure the toe-out angle. This is the difference in the steer angle between the outside wheel and the inside wheel when the inside wheel is steered through 20°. If substantial deviations are found, the cause may be one of the following, assuming that the caster is correct and the camber is set correctly: Toe not adjusted in straight-ahead position of steering, resulting in tie rods of unequal length. The steering knuckle or tie rod is bent. Excessively large deviations in the front-end assembly and front axle carrier on vehicles involved in an accident: Longitudinal frame member Crossmember Wheel well Firewall, that acts unfavorably on the adjustment ranges for camber and caster so that large difference arise in the toe-out angle between left and right. Toe-out angle with inner wheel steered through 20°	*BE40.20-P-1001-08W

CHECK VALUES FOR TOE-OUT ANGLE

Number	Designation		Model 463 (except 463.276/277) as of model year 2019	Model 463.276/277 as of model year 2019
BE40.20-P-1001-08W	Toe-out angle with inner wheel steered through 20°	∠°	-1°18' (±30')	-1°18' (±30')