Remove/Install Trailing Arm - AR35.20-P-0100GW

Model 463 (except 463.270/271) 

as of model year 2013 up to model year 2019 

Fig 1: Trailing Arm Components Location - Model 463 (Except 463.270/271) Up To Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Remove/install
1	Secure vehicle against rolling away and then raise		AR00.60-P-1000G
2	Detach mounting clamps of hand brake cable on trailing arm (1)
3	Unscrew nuts of level sensor mounting bar and place level sensor linkage to one side	When removing trailing arm (1) on left side of vehicle.
4	Unscrew nut (2) for fixing the trailing arm (1) to the frame	The nut (2) must only be removed when the suspension is in its compressed state. It must be ensured that the elastomer bearings are seated correctly. Nut, trailing arm to frame	*BA35.15-P-1001-02A
5	Remove screws/bolts (3) securing trailing arm (1) to rear axle	The screws/bolts (3) must only be removed when the suspension is in its compressed state. Nut/bolt, trailing arm to axle	*BA35.15-P-1002-02A
6	Remove trailing arm (1)
	Check
7	Check elastomer bearings for damage	If a problem arises
		↓
		Replace elastomer bearings at trailing arm
			AR35.15-P-0101GW
8	Install in the reverse order