Remove/Install Front Wheel Hub - AR33.20-P-0310XG
Model 463
as of model year 2019
Shown on left side of vehicle
| Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | ||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Remove steering knuckle. | AR33.25-P-0400XG | |
| 2 | Unscrew bolts (2). | *BA33.20-P-1012-01C | |
| 3 | Take off wheel hub (3). | ||
| 4 | Install in reverse order. | ||
| Check | |||
| 5 | Check condition of steering knuckle (1), of guide bearing on upper transverse control arm or of supporting joint on lower transverse control arm, and of tie rod end. | If the components are damaged, ↓ replace corresponding component parts. |
WHEEL CONTROL, HUB
| Number | Designation | Model 463 as of model year 2019 | |||
|---|---|---|---|---|---|
| BA33.20-P-1012-01C | Bolt, wheel bearing to steering knuckle | M12 | Stage 1 | Nm | 80 |
| Stage 2 | ∠0 | 45 | |||