Remove/install dashboard - AR68.10-P-1000LW
MODEL 205
Shown with TRANSMISSION 722
Model 205 with transmission 722, 724, 725
Model 205 with transmission 716
Shown with TRANSMISSION 722
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | AH91.00-P-0004-01A | ||
| Remove/install | |||
| 1 | Move driver and passenger front seat toward rear to end position | ||
| 2 | Position steering wheel rearwards and at the bottom | ||
| 3 | Disconnect battery ground line | AR54.10-P-0003LW | |
| 4 | Remove cover below left of instrument panel | AR68.10-P-1500LW | |
| 5 | Remove paneling from left and right A-pillars | AR68.30-P-4050LW | |
| 6 | Remove left air vent | AR83.10-P-4501LW | |
| 7 | Remove steering column tube module | AR54.25-P-2802LW | |
| 8 | Remove instrument cluster | AR54.30-P-6015LW | |
| 9 | Remove Audio/COMAND display | AR82.60-P-7722LW | |
| 10 | Remove speaker | MODEL 205 with CODE 348 (Emergency call/assistant system) MODEL 205 with CODE 810 (Sound system) |
|
| AR82.62-P-7833LW | |||
| 11 | Remove center console | MODEL 205.0/2 with TRANSMISSION 716 | AR68.20-P-2000LWA |
| MODEL 205 with TRANSMISSION 722, 724, 725 | AR68.20-P-2000LW | ||
| 12 | Remove heat unit | MODEL 205 with CODE 520 (Audio 20 USB) MODEL 205 with CODE 522 (Audio 20 radio) MODEL 205 with CODE 531 (COMAND APS) |
|
| AR82.85-P-1100LW | |||
| 13 | Remove right air vent | AR83.10-P-4502LW | |
| 14 | Remove glove compartment | AR68.10-P-1400LW | |
| 15 | Detach seal (2) in area of cover (3) | ||
| 16 | Remove cover (3) from instrument panel (1) | Fig 7 | |
| 17 | Unclip cover (4) from head-up display (A40/12) and remove (arrow A) | MODEL 205 with CODE 463 (Head-up display) |
|
| Fig 8 | |||
| 18 | Cover head-up display (A40/12) | MODEL 205 with CODE 463 (Head-up display) Otherwise head-up display (A40/12) can be scratched. |
|
| 19 | Remove bolts (5) from instrument panel (1) | ||
| 20 | Unscrew bolt (30) from passenger airbag (7) | MODEL 205.0/1/2 |
*BA91.60-P-1002-01O |
| 21.1 | Unclip left rear air duct (8) and right rear air duct (9) from instrument panel (1) (arrows B) | MODEL 205 with TRANSMISSION 722, 724, 725 |
|
| 21.2 | Unhook left rear air duct (28) and right rear air duct (29) from instrument panel (1) (arrows F) | MODEL 205 with TRANSMISSION 716 |
|
| 22 | Unclip wiring harness from instrument panel (1) (arrow C) | Fig 8 | |
| 23 | Unlock left fuse and relay module (K40/6) at retaining tabs (11) and swivel out of instrument panel (1) (arrow D) | ||
| 24 | Unlock fuse holder (12) on left fuse and relay module (K40/6) (arrows E) and disconnect | ||
| 25 | Remove fuse holder (13) on left fuse and relay module (K40/6) | ||
| 26 | Disconnect electrical connector (14) from left fuse and relay module (K40/6) | ||
| 27 | Remove rear insulation mat from left fuse and relay module (K40/6) | ||
| 28 | Disconnect electrical connector (16) from exterior lights switch (S1) | ||
| 29 | Disconnect electrical connector (15) from driver side instrument panel button group (S6/1) | MODEL 205 with CODE 235 (Active Parking Assist) MODEL 205 with CODE 238 (Active lane keeping Assist) MODEL 205 with CODE 266 (DISTRONIC PLUS with Steer Assist and Stop & Go Pilot) MODEL 205 with CODE 463 (Head-up display) MODEL 205 with CODE 501 (360° camera) |
|
| 30 | Disconnect electrical connection (17) from parking brake electrical switch (S76/15) | ||
| 31 | Disconnect electrical connector (18) from electronic ignition lock control unit (N73) | ||
| 32 | Move electrical line (19) and wiring harness (20) out of instrument panel (1) on left | ||
| 33 | Move wiring harnesses (21 and 22) out of instrument panel (1) in area of steering column | ||
| 34 | Unhook Bluetooth® antenna (A2/91) and electrical line (25) from instrument panel (1) | ||
| 35 | Remove insulation mats in area of center console | ||
| 36 | Move wiring harnesses (23 and 24) out of instrument panel (1) in area of center console | ||
| 37 | Guide electrical lines (26) out of instrument panel (1) in upper area | ||
| 38 | Guide electrical line (27) out of instrument panel (1) at top | MODEL 205 with CODE 348 (Emergency call/assistant system) MODEL 205 with CODE 810 (Sound system) |
|
| 39 | Pull instrument panel (1) toward rear until electrical connectors (6) on passenger airbag (7) are accessible | ||
| 40 | Disconnect electrical connectors (6) from passenger airbag (7) | ||
| 41 | Remove instrument panel (1) and remove through passenger side | ||
| 42 | Install in the reverse order |
AIRBAG
| Number | Designation | MODEL 205.0/1/2 | |
|---|---|---|---|
| BA91.60-P-1002-01O | Screw/bolt, front passenger airbag unit to crossmember | Nm | 3 |