Remove/Install Radar Sensor For Driver Assistance System In Rear Bumper - AR54.71-P-0003LW
Model 205.0/2/3/4
with code 238 (Active lane keeping Assist)
Model 205.0/2/3/4
with code 253 (Rear impact warning and protection system)
Model 253
with code 238 (Active lane keeping Assist)
Model 253
with code 253 (Rear impact warning and protection system)
MODIFICATION NOTES
| 18.02.2019 | Commission rear center bumper radar sensor (B92/1). | Step 5 |
Shown on model 205.0
Fig 1: Radar Sensor For Driver Assistance System In Rear Bumper Components Location - Model 205.0/3/4 With Code(s) 238 And 253
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on preventing damage to electronic components due to a magnetic tool | AH54.00-P-0002-01A | ||
| Remove/install | |||
| 1 | Remove rear bumper (1). | Model 205.2 with code 238 (Active lane keeping Assist) Model 205.2 with code 253 (Rear impact warning and protection system) |
AR88.20-P-2200LWS |
| Model 205.0/3/4 with code 238 (Active lane keeping Assist) Model 205.0/3/4 with code 253 (Rear impact warning and protection system) |
AR88.20-P-2200LW | ||
| Model 253 with code 238 (Active lane keeping Assist) Model 253 with code 253 (Rear impact warning and protection system) |
AR88.20-P-2200LWG | ||
| 2 | Release and disconnect electrical connector (2) from rear center bumper radar sensor (B92/1). | ||
| 3 | Release holder (3) and remove rear center bumper radar sensor (B92/1). | ||
| 4 | Install in the reverse order. | ||
| 5 | Commission rear center bumper radar sensor (B92/1). | When replacing rear center bumper radar sensor (B92/1). | |
| AD00.00-P-2000-04B |