Remove/install stabilizer bar on front axle - AR32.20-P-0300LW
MODEL 205 without CODE M005 (Vehicles with 4MATIC/all-wheel drive)
MODIFICATION NOTES
| 11.9.14 | Schraube Drehstab an Langstrager | Type 205 except 4MATIC | *BA32.20-P-1001-02R |
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Lower front axle | AR33.10-P-0101LW | |
| 2 | Detach torsion bar link rods (2) from torsion bar (1) | MODEL 205 without CODE M005 (Vehicles with 4MATIC/all-wheel drive) |
AR32.35-P-3328LW |
| 3 | Unscrew bolts (3), take off mounting bar (4) and remove torsion bar (1) | ||
| *BA32.20-P-1001-02R | |||
| 4 | Install in the reverse order | ||
| 5 | Perform wheel alignment check | AR40.20-P-0200LW |
FRONT AXLE STABILIZER BAR
| Number | Designation | Model 205 except 4MATIC | |
|---|---|---|---|
| *BA32.20-P-1004-02R | Screw/bolt, stabilizer bar to longitudinal member | Nm | 70 |