Remove/install front seat backrest - AR91.10-P-1060LW

Model 205.0/1/2

Model 253

Fig 1: Identifying Front Seat Backrest Remove/Install Components - Shown On Front Passenger Seat

G10135099

Courtesy of MERCEDES-BENZ USA

Shown on front passenger seat with CODE 876 (Interior lights package)

	Remove/install
1	Remove left or right front seat		AR91.10-P-1000LW
2	Remove paneling on front seat frame		AR91.10-P-1200LW
3	Remove left rear footwell lamp (E17/17) or right rear footwell lamp (E17/18) and place to one side with lines attached	Model 205.0/1/2 with code 876 (Interior Light package) Model 253 with code 876 (Interior Light package)
4	Unhook tabs (2) of seat cushion cover
5	Expose electrical wiring harness (4), disconnect its electrical connectors and remove it from bracket (1)	Ensure that electrical wiring harness (4) is routed and secured without chafing. Damage can otherwise occur. The number of electrical connectors is dependent on the vehicle equipment.
6	Remove bolts (5)	Bolt, backrest to seat frame	*BA91.10-P-1002-01T
7	Remove backrest (3) from seat frame
8	Lift seat cushion and guide out electrical wiring harness (4) between seat cushion and seat frame
9	Install in the reverse order

FRONT SEATS

Number	Designation		Model 205	Model 253
BA91.10-P-1002-01T	Bolt, backrest to seat frame	Nm	40	40