Remove/install backup camera - AR54.65-P-0030RK
MODEL 231
with CODE 218 (Rear view camera)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and remove transmitter key | ||
| 2 | Remove paneling on trunk lid | AR68.30-P-8150RK | |
| 3 | Detach reversing camera electrical connector 1 (B84/3x1) from trunk lid | ||
| 4 | Detach reversing camera electrical connector 2 (B84/3x2) from trunk lid | Model 231 up to model year 2014 with code 218 (Rear view camera) |
AR54.65-P-0013-01NKB |
| 5 | Unplug reversing camera electrical connector 1 (B84/3x1) and reversing camera electrical connector 2 (B84/3x2) and expose electrical lines | ||
| 6 | Detach electrical connection (2) from external operation switch for trunk lid (S88/8) | ||
| 7 | Unscrew nuts (3) and remove external operation switch for trunk lid (S88/8) | ||
| 8 | Remove retaining clip (4) and detach reversing camera (B84/3) from trunk lid external operation switch (S88/8) | ||
| 9 | Install in the reverse order | ||
| 10 | Calibrate reversing camera (B84/3) using the diagnostic system and calibration device | AD00.00-P-2000-04A | |
| Fig 2 |