Remove/install trunk lid paneling - AR68.30-P-8150RK

MODEL 231 

Fig 1: Trunk Lid Paneling Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
	Remove/install
	Risk of injury  . Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of the mechanism when the components are moving.	AS00.00-Z-0009-01A
1	Open Vario roof fully
2	Remove plug-in clips (1)	Replace damaged plug-in clips (1).
3	Unclip retaining clips (3) from cover (2) at bottom of trunk lid	Remove cover (2) until electrical connectors (4) are accessible.
4	Disconnect electrical connectors (4)
5	Remove hazard warning triangle from bracket (5)
6	Unclip bracket (5) and remove in direction of arrow
7	Unclip plug-in clips (6) and remove paneling (7)	Replace damaged plug-in clips (6).
8	Install in the reverse order