Remove/install side wall lining - AR68.30-P-1450GX

MODEL 463.236 /237, 463.243 /245 /246 /248 /249 as of 1.6.04, 463.270 /271, 463.323 /333 as of 1.6.04, 463.341 /346 

Fig 1: Identifying Side Wall Lining Components

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Mounting Clamp

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove longitudinal bench seat	Only on model 463.236/243/245/246/248/249/270/271/323/333/341/346 with side-facing bench seal in cargo area	AR91.12-P-1200A
2	Remove paneling (2) from rear pillar		AR68.30-P-4505GK
3	Remove door rubber seal in area of side wall paneling (4)
4	Remove rear seat belt	Only remove belt end fitting and upper belt guide fitting.
		Only on model 463.237/243/245/246 /249/270 /271/323/333/341/346, Model 463.236/248 except code (979) Special protection version	AR91.40-P-0681GN
		Only on model 463.236/248 with code (979) Special protection version	AR91.40-P-0681PM
5	Press mounting clips (6) on side wall paneling (4) off of door bead	Installation:  Remove mounting clips (6) from side wall paneling (4) and install on door bead, then install side wall paneling (4)
6	Remove side wall paneling (4) from side wall at bottom and rear (arrows)	The side wall lining (4) is fastened with expansion clips (7) and must be removed carefully to prevent damage. Installation:  Replace expansion clips (7).
7	Pull side wall paneling (4) out of window seal (5) starting at bottom	Carefully pull side wall paneling (4). Danger of breakage! Do not damage connections in window antennas
8	Remove side wall lining (4)	The side wall paneling (4) is fastened above with the window with a Velcro strip (8) and inserted below the roof paneling in the front area.
9	Pull belt out of side wall paneling (4)
10	Install in the reverse order