Remove/install panoramic sliding roof motor - AR77.21-P-6995EW

MODEL 204.3, 207.3, 212.0/1/2 with CODE 413 (Panoramic glass roof with top sliding roof)

Shown on model 212.0

Fig 1: Panoramic Sliding Roof Motor Remove/Install Components

G09977491

INSTALLATION IMPORTANT

REFER TO SELF-DIAGNOSTIC SYSTEMS

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1.1	Loosen headliner (1) in front area	MODEL 204.3, 207.3 with CODE 413 (Panoramic glass roof with top sliding roof)
1.1	Loosen headliner (1) in front area		AR68.30-P-4300EC
1.2	Loosen headliner (1) in front area up to B-pillars	MODEL 212 with CODE 413 (Panoramic glass roof with top sliding roof) MODEL 212.0/1 with CODE 413 (Panoramic glass roof with top sliding roof)
1.2	Loosen headliner (1) in front area up to B-pillars		AR68.30-P-4300EW
2	Lower headliner (1) and disconnect electrical connector (3) on panoramic sliding sunroof control module (A98)	Carefully lower headliner (1). Headliner (1) can be damaged.
3	Lower headliner (1), remove bolts (2) and take out panoramic sliding sunroof control module (A98)	Carefully lower headliner (1). Headliner (1) can be damaged. First position bolts (2) and then tighten.
4	Install in the reverse order
5	Perform teach-in run for anti-pinch protection and normalization of panoramic sliding sunroof
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A