Remove/install panoramic roof wind deflector - AR77.21-P-0100EW

MODEL 204.3, 207.3, 212.0/1/2 with CODE (413) Panoramic glass roof with top sliding roof 

Shown on model 212.0 

Fig 1: Panoramic Roof Wind Deflector Remove/Install Components - Shown On Model 212.0

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Open front glass cover
2	Remove cover (4) and screws (5)	Pull wind deflector (1) downwards and slide until it lies flush with the seal (3). Then tighten the bolts (5).
3	Check seal (3) for front glass cover (10), replace if necessary.	Lay wind deflector (1) down toward rear until seal (3) is accessible.
		Lubricant, rubber assembly 1 l	*BR00.45-Z-1010-06A
4	Lie wind deflector (1) forwards and remove springs (7)	Only when replacing springs (7).
5	Remove left drip rail (2) on panoramic roof		AR88.80-P-4000EW
6	Pull the terminal strip (9) found on the mesh (6) of the wind deflector (1) out to the left of the guide rail (8) and remove wind deflector (1)
7	Install in the reverse order