Remove/install drip rail - AR88.80-P-4000EW

MODEL 204.3, 207.3, 212

Shown on model 212.0 with CODE (413) Panoramic sliding roof

Fig 1: Drip Rail Remove/Install Components - Shown On Model 212.0 With Code (413) (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Drip Rail Remove/Install Components - Shown On Model 212.0 With Code (413) (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove roof railing	Model 212.2 only
2.1	Unclip drip rail (1) from clips (4) starting at rear (arrow B) and remove	On vehicles with CODE (413) Panoramic sliding roof Installation: Insert drip rail (1) into water deflector (2) in front area (arrow A) and clip into clips (4). Ensure that the sealing ring (3) is located above the drip rail (1).
2.1		Mounting wedge	Figure
2.2	Unclip drip rail (1) from clips (7) and retaining tabs (5) starting at front and remove	On vehicles without CODE (413) Panoramic sliding roof Check clips (6) for damage, replace if necessary. Installation: Ensure that the sealing ring (3) is located above the drip rail (1).
2.2		Mounting wedge	Figure
3	Install in the reverse order

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA