Remove/install charge air manifold - AR09.41-P-1310RKC

ENGINE 279 in MODEL 231 

Fig 1: Charge Air Manifold Remove/Install Component (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Charge Air Manifold Remove/Install Component (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove fuel distributor with injection valves		AR07.03-P-1451RKC
2	Remove screw/bolt (1)
3	Release clamps (2) and remove low-temperature circuit coolant pipes (3)
4	Release vacuum lines (4) on the charge air distributor (5) at the rear and detach
5	Release clamp (6) and disconnect hose (7) and place to one side
6	Remove screw/bolts (8)	Replace screw/bolts (8). Bolt, charge air distributor to cylinder head	*BA09.41-P-1004-01Q
7	Remove charge air distributor (5)	Replace seals.
8	Install in the reverse order

CHARGE AIR PIPE/CHARGE AIR COOLING

Number	Designation			ENGINE 279
BA09.41-P-1004-01Q	Bolt, charge air distributor to cylinder head	Stage 1	Nm	4
		Stage 2	∠°	180