Remove and install DC/AC converter control unit - AR54.21-P-1600LF
MODEL 222
with CODE U67 (230 V socket in the rear)
without CODE Z22 (Panic alarm system)
MODEL 222
with CODE U80 (115 V socket)
without CODE Z22 (Panic alarm system)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of death from touching live components with AC voltages over 30 V | Do not touch live parts. Persons who have electronic implants (e.g. cardiac pacemakers) must not perform any work on components conducting AC voltage greater than 30 V. | AS54.00-Z-0001-05A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Trim in right of luggage compartment | AR68.30-P-4600LF | |
| 3 | Remove rear seat control unit | MODEL 222.0/1 with CODE 223 (Electrically adjustable rear bench seat) with CODE U67 (230 V socket in the rear) without CODE Z22 (Panic alarm system) MODEL 222.0/1 with CODE 223 (Electrically adjustable rear bench seat) with CODE U80 (115 V socket) without CODE Z22 (Panic alarm system) |
AR91.29-P-1570LFA |
| 4 | Remove trailer recognition control unit | MODEL 222.0/1 with CODE 550 (Trailer coupling) with CODE U67 (230 V socket in the rear) without CODE Z22 (Panic alarm system) MODEL 222.0/1 with CODE 550 (Trailer coupling) with CODE U80 (115 V socket) without CODE Z22 (Panic alarm system) |
AR31.19-P-1300LF |
| 5 | Remove windshield heater control unit and place to one side with the bracket mounted and electrical lines connected | MODEL 222 with CODE 597 (Heated windshield) with CODE U67 (230 V socket in the rear) without CODE Z22 (Panic alarm system) MODEL 222 with CODE 597 (Heated windshield) with CODE U80 (115 V socket) without CODE Z22 (Panic alarm system) |
AR54.21-P-1603LF |
| 6 | Open cable ties (1) | ||
| 7 | Loosen screws/bolts (3) | ||
| 8 | Unscrew nut (4) | ||
| 9 | Push electrical wiring harness (8) to one side and remove DC/AC converter control unit (N24/3) from strut (2) | ||
| 10 | Route DC/AC converter control unit (N24/3) downwards into trunk | ||
| 11 | Unclip connector housing (5) from bracket (6) | ||
| 12 | Disconnect electrical connection (7) and remove DC/AC converter control unit (N24/3) | ||
| 13 | Remove DC/AC converter control unit (N24/3) from bracket (6) | When replacing DC/AC converter control unit (N24/3). | |
| 14 | Install in the reverse order |