Removing and installing headlamp for daytime running light - AR82.10-P-2300CX
MODEL 204.9 with CODE (236) Daytime running lights in LED design
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Remove front engine compartment paneling | When removing left daytime running lights headlamp (E1/3). | AR61.20-P-1105CY |
| 3 | Detach right fender liner in area of bumper far enough and pry out using assembly wedge until the right daytime running lights headlamp (E2/3) can be removed | When removing right daytime running lights headlamp (E2/3). | |
| Fig 2 | |||
| 4 | Disconnect electrical connector (1) | ||
| 5 | Release catch tabs (2) (arrow) and remove frame (3) with left daytime running lights headlamp (E1/3) or right daytime running lights headlamp (E2/3) from bumper | ||
| 6 | Remove nuts (4) and remove left daytime running lights headlamp (E1/3) or right daytime running lights headlamp (E2/3) from frame (3) | ||
| 7 | Install in the reverse order |