Remove/Install Rear Window Wiper Motor - AR82.30-P-6900GZ

MODEL 164, 166 

Fig 1: Identifying Rear Window Wiper Motor Remove/Install Components - Shown On Model 164.1

Courtesy of MERCEDES-BENZ USA

Shown on model 164.1 

Fig 2: Identifying Rear Window Wiper Motor Remove/Install Components - Illustrated On Model 166.0

Courtesy of MERCEDES-BENZ USA

Illustrated on model 166.0 

	Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.	Always remove ignition key when working on windshield wiper mechanism.	AS82.30-Z-0001-01A
	Remove/install
1	Move wiper motor to parked position
2	Remove rear-end door wiper arm		AR82.30-P-6910GZ
3	Remove door lining from rear-end door	MODEL 164	AR72.20-P-3520GZ
		MODEL 166	AR72.20-P-3520GQ
4	Remove screws/bolts (4) and remove cover plate (5)	MODEL 166 with CODE Z04 (Light armoring)
		Bolt, wiper motor cover to rear-end door	*BA82.30-P-1006-01J
5	Disconnect electrical connector (1)
6	Remove screws/bolts (2) from rear-end door wiper motor	Bolt on wiper motor	*BA82.30-P-1001-01J
7	Remove rear-end door wiper motor (M6/4)	Replace rubber passage of rear window (3) if necessary. Pay attention to installation position.
8	Install in the reverse order