Retrofit Drive Kit Plus for Apple iPhone - AZ82.60-P-0019SC

MODEL 216.3 (except 216.374/377/379) 

without CODE 526 (COMAND with single DVD drive (without navigation)) 

without CODE 863 (Digital/analog TV tuner) except Mercedes-Benz InCar Internet 

Routing schematic, Drive Kit Plus for the Apple iPhone 4, shown on left-hand drive vehicle 

Fig 1: Apple iPhone 4 Drive Kit Plus Routing Schematic Diagram - Shown On Left-Hand Drive Vehicle

Courtesy of MERCEDES-BENZ USA

Routing schematic, Drive Kit Plus for the Apple iPhone 5, shown on left-hand drive vehicle 

Fig 2: Apple iPhone 5 Drive Kit Plus Routing Schematic Diagram - Shown On Left-Hand Drive Vehicle

Courtesy of MERCEDES-BENZ USA

	Notes on avoiding damage to optical fibers during repair work		AH82.60-P-0001-05AK
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove
1	Move front passenger seat toward rear
2	Remove COMAND display (A40/8)
			AR82.85-P-7429SX
3	Remove COMAND controller unit (A40/3)
			AR82.85-P-1100SC
4	Remove glove compartment
			AR68.10-P-1400SX
	Install
5	Prepare vehicle for retrofitting of Drive Kit Plus for the Apple iPhone		AZ82.60-P-0019-08SX
6	Retrofit Drive Kit Plus adapter wiring harness (3)		AZ82.60-P-0019-01SX
7	Retrofit low voltage differential signal (LVDS) wiring harness	MODEL 216.3 up to 31.05.2009 up to model year 2009 and MODEL 216.3 with CODE 529 (HIGH Class Japan)	AZ82.85-P-0004-03SX
		MODEL 216.3 as of 01.06.2009 as of model year 2010 without CODE 529 (HIGH Class Japan)	AZ82.60-P-0019-04SX
8	Retrofit Drive Kit Plus connector wiring harness and Drive Kit Plus Media Interface adapter line		AZ82.60-P-0019-02SX
		The Drive Kit Plus Media Interface adapter line is only installed with CODE 518 (Media Interface). Clarify with the customer whether the iPhone cradle is to be installed.
9	Retrofit Drive Kit Plus control unit (1)		AZ82.60-P-0019-03SX
10	Partially install glove compartment	When retrofitting the Drive Kit Plus for the Apple iPhone 5.
			AR68.10-P-1400SX
		Install the glove compartment far enough so that the Bluetooth module (35) can be installed.
11	Retrofit Bluetooth module (35)	When retrofitting the Drive Kit Plus for the Apple iPhone 5.
			AZ82.60-P-0019-07SX
12	Install remaining parts
	Update Vehicle Documentation (VeDoc)
13	Attach note "Drive Kit Plus for the Apple iPhone retrofitted as per AZ82.60-P-0019SC " under field organization texts .
14	Update special equipment through VeDoc in the online vehicle data card	Ensure here that the third digit is the letter "o" for Oscar.
15	Connect diagnostic system and select vehicle via the vehicle identification number (VIN)
			AD00.00-P-2000-04A
16	Carry out adaptation and redocumentation of the "Drive Kit Plus" control unit	Only with "Car-to-X" XENTRY: "Drive Kit Plus" control unit > Adaptation > Initial startup
17	Perform variant coding with XENTRY using the software calibration number (SCN)	Register Drive Kit Plus for the Apple iPhone with the audio component using SCN coding.
18	Close off diagnostic system
			AD00.00-P-2000-04A
19	Install software onto USB stick and flash to Drive Kit Plus control unit via Apple iPhone® update adapter	For instructions see ODUS: Service and Downloads > Further Information > Accessories > Telematics > Drive Kit Plus.
	Check
20	Perform function check of Drive Kit Plus for the Apple iPhone	See Owner's Manual.