Navigation mode, function - GF82.85-P-2012GZJ

MODEL 164.1/8, 251 with CODE (498) Japan version with CODE (529) HIGH Class Japan up to Model Year 2008 

Function 

The navigation processor is integrated into the COMAND operating, display and control unit (A40/3) and can be controlled on the screen.

The GPS receiver and the yaw rate sensor (Gyro) required by the navigation are integrated into the COMAND operating, display and control unit.

The COMAND operating, display and control unit is responsible for displaying maps and pictograms, as well as the general management of navigation entries.

The VICS (V  ehicle I  nformation and C  ommunications S  ystem) control unit available widely in Japan as a dealer option enables realization of the dynamic destination-oriented navigation. Dynamic destination-oriented navigation is a special form of navigation, in which current traffic messages are incorporated into the route calculation.

The following navigation functions can be configured using the menu: 

• "MENU"
  • Selected destination
  • Set memory point
  • Search
  • Nearest point
  • Set navigation settings
  • Set VICS setting
• "DISP"
• "RRE ROUTE"
• "STOP OVER"
• "DEST INFO"
• "WIDE AREA"
• "DETAIL"
• "GUIDE"
• "MEMO SET"
• "ADJ"