Removal And Install Electric Motor Of The Electric Step - Ar88.30-D-8505TS
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2018 Mercedes-Benz Sprinter 3500XD, 2018 Mercedes-Benz Sprinter 3500, 2018 Mercedes-Benz Sprinter 2500, 2017 Mercedes-Benz Sprinter 3500XD, and 2017 Mercedes-Benz Sprinter 3500. However, it is still accessible from the selected car via links, so may be relevant.
Type 906
with code T57 (electric step, loading space sliding door, right)
Type 906
with code T58 (electric step, loading space sliding door, left)
| Risk of injury
from cuts or Scratches on sharp-edged vehicle parts |
Always when working on or in the area of sharp, unburred vehicle parts Wear protective gloves. Deburr the repair panels. |
AS00.00-Z-0017-01A | |
| Expand | |||
| 1 | Remove gear (2). | AR88.30-D-8506TS | |
| 2 | Unscrew the screws (4). | ||
| 3 | Remove the holder (3). | AR88.30-D-8504TS | |
| 4 | Put electrical wiring harness (5) to one side. | ||
| 5 | Cut the cable ties (6). | ||
| 6 | Detach electrical cables (7) and electrical cable sets (8) from the electric motor (1). | ||
| 7 | Cut electrical lines (7) (arrow A). | ||
| 8 | Remove the electric motor (1). | ||
| Build in | |||
| 9 | Strip the ends of the electrical lines (7) remaining on the step. | ||
| 10 | Position the new electric motor (1). | ||
| 11 | Ends of the electrical lines (7) of the new electric motor (1) with the ends of the electrical lines remaining on the step Connect lines (7) with crimp connectors. |
Pay attention to the color coding of the electrical lines (7). Otherwise the electric motor (1) can be damaged. |
|
| 12 | Position the electrical cables (7) and the electrical cable sets (8) on the new electric motor (1) and fix them with a new cable tie. | ||
| 13 | Position the holder (3) on the new electric motor (1) and install it. | AR88.30-D-8504TS | |
| 14 | Screw in the screws (4). | *BA88.30-N-1007-02A | |
| 15 | Install gear (2). | AR88.30-D-8506TS |
ELECTRIC STEPS
| Number | Designation | Type 906 apart from code P0E (master code Sprinter Tourer 16 + 1 domestic) apart from code P0F (master code Sprinter Tourer 19 + 1 domestic) apart from code P0G (master code Sprinter Tourer 16 + 1) apart from code P0H (master code Sprinter Tourer 19 + 1) apart from code PE4 (master code bus DCAA from Argen) apart from code PE5 (master code bus platform seating from Argen) | |
|---|---|---|---|
| BA88.30-N-1007-02A | Screw the electric motor to the holder | Nm | 6 |