LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2011 >> SLK300 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Electrical System - Engine -- 203 Chassis) >> Testing & Repair >> Removing and installing the starter - AR15.30-P-7100P

Removing and installing the starter - AR15.30-P-7100P

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 111.951 in MODELS 203.035 /235 /735 

ENGINE 111.955 in MODELS 203.045 /245 /745 

ENGINE 112.912 in MODELS 203.061 /261, 209.361 /461 

ENGINE 112.946 in MODELS 203.064 /264 

ENGINE 112.955 in MODELS 209.365 /465 

ENGINE 113.968 in MODELS 209.375 /475 

ENGINE 113.987 in MODELS 209.376 /476 

ENGINE 113.988 in MODELS 203.076 /276 

Illustrated on the engine 111.951 in model 203.035 

Fig 1: Identifying Starter Remove/Install Components - Illustrated On Engine 111.951 In Model 203.035
G04715170
MODIFICATION NOTES

3.9.03 Check ring gear, newly recorded Step 10  
REMOVINGINSTALLING Removing/installing    
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
DANGER Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and safety glasses. Only pour battery acid into suitable and appropriately marked containers. AS54.10-Z-0001-01A
NOTES Notes on self-locking nuts and bolts All models AH00.00-N-0001-01A
1 Disconnect ground cable from battery NOTES Do not connect quiescent current retention unit. Risk of short circuit!  
    Model 203 AR54.10-P-0003P
    Model 209 AR54.10-P-0003Q
NOTES Notes on battery All models AH54.10-P-0001-01A
2 Detach lower engine compartment paneling   AR61.20-P-1105P
3.1 Completely remove exhaust system Model 203 with engine 111 AR49.10-P-7000PR
    Models 203, 209 with engine 112 AR49.10-P-7000PV
    Model 203 with engine 113 AR49.10-P-7000AC
3.2 Remove center bracket of exhaust system Model 209 with engine 113  
4.1 Remove right engine mount Model 209 with engine 113 AR22.10-P-1100PV
5 Dismount electrical line circuit 30 (2) TORQUE SPECIFICATION *BA15.30-P-1001-01A 
6 Dismount electrical line circuit 50 (3) TORQUE SPECIFICATION *BA15.30-P-1002-01A 
7 Unscrew bolts (6) TORQUE SPECIFICATION *BA15.30-P-1003-01A 
8 Place bracket (5) and cable harness (4) to the side    
9.1 Take starter (M1) down and out Model 203 with engines 111, 112, 113
Model 209 with engine 112
 
9.2 Guide starter (M1) to the front of vehicle and take out toward bottom Model 209 with engine 113  
10.1 Check ring gear at flywheel for wear and damage IMPORTANT When replacing the starter on vehicles fitted with a manual transmission.  
    IMPORTANT Rotate engine at the crankshaft in direction of rotation.  
10.2 Check ring gear on the drive plate for wear and damage IMPORTANT When replacing the starter on vehicles fitted with automatic transmission.  
    IMPORTANT Rotate engine at the crankshaft in direction of rotation.  
11 Install in reverse order    
12 Perform function check    
13 Render electrical system operational See ↓
Perform basic programming
 
    Model 203 AR00.19-P-0200P
    Model 209 AR00.19-P-0200Q
14 Read out fault memory and erase IMPORTANT When the work is complete, stored faults must be worked on in the diagnostic fault code memories and erased. ↓  
REFER TO SELF-DIAGNOSTIC SYSTEMS Connect STAR DIAGNOSIS and read out fault memory   AD00.00-P-2000-04A
    Diagnosis system STAR DIAGNOSIS, Compact Passenger Car *WH58.30-Z-1048-13A 
TORQUE SPECIFICATION STARTER

Number Designation Engines 103, 104, 111, 120 Engine 112 except 112.951, 113.94/ 96/98 Engine 113.987 in model 209 Engines 113.988 203
BA15.30-P-1001-01A Nut of connection for circuit 30 Nm 14 14 14 14
BA15.30-P-1002-01A Nut of connection for circuit 50 Nm 6 6 6 6
BA15.30-P-1003-01A Bolt for starter on crankcase Nm 42 42 40 40
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1048-13A STAR DIAGNOSIS diagnosis system, Compact Passenger Car 6511 1801 00