Remove/install antenna - AR82.70-P-8951CY

MODEL 204.9 

Fig 1: Identifying Antenna Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Detach headliner from roof paneling and place down on the seats as far forward as possible with electrical lines connected	Do not damage headliner when performing the following operation steps.	AR68.30-P-4300CY
2	Expose antenna lines (3) and disconnect electrical connectors (5) of antenna lines (3)	Observe installation position of antenna lines (3). The number of antenna lines (3) and electrical connectors (5) depends on the vehicle equipment specification. Pay attention to routing and securing of antenna lines (3) in cable duct (4) and at roof paneling.
3	Unscrew screw/bolt (1) and remove together with bracket (2).
4	Detach mobile phone and global positioning system roof antenna (A2/49) from roof and pull out of vehicle roof together with antenna lines (3)	The mobile phone and global positioning system roof antenna (A2/49) must not be dismantled, as this results in damage. Check the seal (6), replace if necessary and clean sealing surfaces.
			*BA82.62-P-1001-01D
5	Install in the reverse order

ANTENNA

Number	Designation		Model 204
BA82.62-P-1001-01D	Screw, antenna base to vehicle roof	Nm	3