LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2011 >> C350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Entertainment, Lighting, Navigation & Wiper/Washer -- Testing & Repair -- C300 (204.054)) >> Testing & Repair >> Remove/install antenna - AR82.70-P-8951CW

Remove/install antenna - AR82.70-P-8951CW

WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 204.0 Roof antenna and dummy roof antenna 

Fig 1: Identifying Antenna Components
G00516901Courtesy of MERCEDES-BENZ USA
REMOVINGINSTALLING Remove/install     
1 Remove headliner from roof paneling and place down as far forward as possible on the seats   AR68.30-P-4300CW
2 Release right-hand paneling (2) in upper area far enough until the electrical connectors (3) are accessible Only when removing the multifunction antenna (A28/11) with code (386) Mobile phone, with code (389) Mobile phone preinstallation with universal interface USA/Canada, with code (359) TELE AID emergency call system, with code (511) Audio 50 APS with DVD changer, with code (525) MB Audio 50 APS radio, with code (512) COMAND APS with DVD changer, with code (527) COMAND APS with single DVD drive (with navigation), with code (537) Digital radio and with code (536) SIRIUS satellite radio)  
3 Expose antenna lines (4) and disconnect electrical connectors (3) of antenna lines (4) Only when removing the multifunction antenna (A28/11) with code (386) Mobile phone, with code (389) Mobile phone preinstallation with universal interface USA/Canada, with code (359) TELE AID emergency call system, with code (511) Audio 50 APS with DVD changer, with code (525) MB Audio 50 APS radio, with code (512) COMAND APS with DVD changer, with code (527) COMAND APS with single DVD drive (with navigation), with code (537) Digital radio and with code (536) SIRIUS satellite radio)
IMPORTANT The number of antenna lines (4) and electrical connectors (3) depends on the vehicle equipment specification.
IMPORTANTInstallation:  Note color coding of electrical connectors (3).
 
4 Unscrew nut (5) and detach roof antenna mock-up (1) or multifunction antenna (A28/11) from roof NOTES The multifunction antenna (A28/11) must not be dismantled, since this will cause damage.
IMPORTANTInstallation:  Check the seal (6), replace if necessary and clean sealing surfaces.
 
TORQUE SPECIFICATION *BA82.62-P-1001-01D 
5 Install in the reverse order    
ANTENNA

Number Designation Model 204
BA82.62-P-1001-01D Screw, antenna base to vehicle roof Nm 3