Remove/install door pocket - AR72.10-P-1040V

MODEL 171.4 

Fig 1: Identifying Door Pocket Components

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove door liner (1) from left and right front door	Put down door liner (2) on a suitable base to avoid damage.	AR72.10-P-1000V
2.1	Unclip left door entrance/exit lamp (E17/3) or right door entrance/exit lamp (E17/4) from door liner (2) and lay down to side together with connected wiring harness until the plastic bonded points (3) are accessible.	Only on vehicles with code (876) Interior light package
3	Separate plastic bonded points (3) of door pocket (1).	Do not operate at excessive speed because the plastic becomes too hot, melts and galls the spherical cutter.
			*WH58.30-Z-1002-01A
4	Remove door pocket (1) and remove plastic residues from door liner (2)
	Install
5	Install door pocket (1)
6	Press clamping plates (4) over pins on door pocket (1)	Use 10 mm socket wrench. Clamping plates (4) should make firm contact to door liner (2).
7.1	Clip left door entrance/exit lamp (E17/3) or right door entrance/exit lamp (E17/4) out door liner (2) and route with connected wiring harness.	Only on vehicles with code (876) Interior light package
8	Install door liner (2) on left and right front door		AR72.10-P-1000V

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1002-01A	Ball cutter, dia. 12 mm