Replace radiator support (without straightening bench) - AR62.30-P-1510V
MODEL 171
| Remove | |||
|---|---|---|---|
| Risk of death cased by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | - | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and undeburred vehicle parts. Deburr replacement panels. |
- | |
| 1 | Raise vehicle. | AR00.60-P-1000V | |
| Fig 2 | |||
| Two-post lift | *WE58.40-Z-1001-05A | ||
| 2 | Remove bottom engine compartment paneling | AR61.20-P-1105V | |
| 3 | Cut open tie strap (3) | ||
| 4 | Unscrew nuts (2) | ||
| 5 | Take off radiator support (1) | ||
| 6 | Transfer bracket (4) | ||
| Install | |||
| 7 | Insert radiator support (1) | ||
| 8 | Tighten radiator support (1) with nut (2) | ||
| 9 | Fasten wiring harness (5) to radiator support (1) with tie strap (3). | ||
| 10 | Install lower engine compartment panel | AR61.20-P-1105V | |
| 11 | Lower vehicle | AR00.60-P-1000V |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-05A | Two-post lifting platform |