Remove/install antenna - AR82.70-P-8951TXA

MODEL 219.3 up to 31.5.06 with CODE (228) Stationary heater with CODE (272) Telephone preinstallation (non-networked) incl. telephone antenna with CODE (386) Preinstallation for telephone "Handy", UPCI system with CODE (388) Telephone "Handy", UPCI system 

Shown on vehicle without code 228 Stationary heater 

Fig 1: Identifying Antenna Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove right side paneling in trunk		AR68.30-P-4800TX
2	Disconnect telephone antenna connector (A2/49a1x1)
3	Undo nut on ground of right luggage compartment wheel well (W7) and remove ground line (7)
4	Remove trim panel (1) on the right
5	Remove telephone antenna line (2) with right grommet (3) out of the right cable duct	Note installation of lines in luggage compartment. Coat right grommet (3) with soapy water. Attach telephone antenna line (2) using self-adhesive felt (8) in area of trunk lid hinge.
6	Pull telephone antenna line (2) out of seal of heated rear window	Insert telephone antenna line (2) into seal of heated rear window using a suitable feeler gauge.
			Figure
7	Separate roof antenna (A2/49) from heated rear window using mounting wedge and remove	Glue on roof antenna (A2/49).	AR82.70-P-8951-01TX
			Figure
		Glass primer	*BR00.45-Z-1023-02A
		Adhesive foil for roof antenna on rear window (when installing old roof antenna (A2/49))	*BR00.45-Z-1079-02A
8	Remove adhesive residue from heated rear window	Cleaner	*BR00.45-Z-1025-04A
9	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Feeler Gauge (129 589 03 21 00)

Courtesy of MERCEDES-BENZ USA