Remove/install left front SAM control unit with fuse and relay box - AR54.21-P-1260T
WARNING: This page is about a different car, the 2009 Mercedes-Benz E350 and 2008 Mercedes-Benz E350. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 211.0/2/6 up to 31.5.06
| Remove/install | |||
| Notes on avoiding damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1.1 | Temporarily store basic data from driver-side SAM control unit with fuse and relay module (N10/1) in STAR DIAGNOSIS | When replacing driver-side SAM control unit with fuse and relay module (N10/1). |
|
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| STAR DIAGNOSIS diagnosis system | *WH58.30-Z-1048-13A | ||
| 2 | Disconnect battery ground cable | Model 211.0/6 | AR54.10-P-0003T |
| Model 211.2 | AR54.10-P-0003TA | ||
| 3 | Release lever (1) in direction of arrow and remove cover (2) from fuse and relay box (3) | ||
| 4 | Separate electrical connectors (4) | ||
| 5 | Detach electrical line (5) from driver-side SAM control unit with fuse and relay module (N10/1) | ||
| 6 | Unscrew bolts (6) and remove driver-side SAM control unit with fuse and relay module (N10/1) from fuse and relay box (3) until electrical connectors on bottom side of driver-side SAM control unit with fuse and relay module (N10/1) are accessible | ||
| 7 | Unplug all electrical connectors from driver-side SAM control unit with fuse and relay module (N10/1). | ||
| 8 | Unclip cutoff relay for interruptible loads (K75) together with bracket from driver-side SAM control unit with fuse and relay module (N10/1) | ||
| 9 | Remove driver-side SAM control unit with fuse and relay module (N10/1) | ||
| 10 | Install in the reverse order |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1048-13A | STAR DIAGNOSIS diagnosis system, Compact Passenger Car | 6511 1801 00 |