Remove/install trim on front door lining - AR72.10-P-1034T

MODEL 211.0/2/6 

Fig 1: Identifying Front Door Lining Trim Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal
1	Remove lining at front door (1)		AR72.10-P-1000T
2.1	Remove mat cover (3)	On Model 211.0/2 with code (413) Panoramic sliding roof or with code (414a) Electric glass sliding roof or with code (954a) Avantgarde or on Model 211.0/2/6 with code (955a) Elegance	AR72.10-P-1030-01T
3.1	Remove retainers (5) and air duct (4)	On vehicles with code (581b) Comfort automatic air conditioning
4	Separate plastic bonding nubs (arrows) from trim (2)	Do not operate at excessive speed because the plastic becomes too hot, melts and galls the saw blade	*WH58.30-Z-1003-20A
			*WH58.30-Z-1005-34A
			*WH58.30-Z-1006-34A
5	Remove trim (2)	Trim (2) must be replaced
	Installation
6	Install trim (2)
7	Install thin washer (7) as spacer on plastic bolts (8)
8	Cut off plastic bolts (8)	Support trim (2) with suitable subsurface and press assembly together in area of plastic bolts (8). Otherwise the plastic bolts (8) are not cut to the correct length and the components are too loose Cut plastic bolts (8) off directly above the thin washer (7)	*WH58.30-Z-1003-20A
			*WH58.30-Z-1005-34A
			*WH58.30-Z-1006-34A
9	Screw bolts (9) with thick washers (10) into cut plastic bolts (8)	Ensure that thick washer (10) is seated correctly
10.1	Install air duct (4)	On vehicles with code (581b) Comfort automatic air conditioning Replace damaged retainers (5).
11.1	Install mat cover (3)	On Model 211.0/2 with code (413) Panoramic sliding roof or with code (414a) Electric glass sliding roof or with code (954a) Avantgarde or on Model 211.0/2/6 with code (955a) Elegance	AR72.10-P-1030-01T
12	Install door lining (1) on front door		AR72.10-P-1000T

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1003-20A	Multicutter
WH58.30-Z-1005-34A	Saw blade, dia. 63 mm (pack of 2)
WH58.30-Z-1006-34A	Screw (only required for multicutter)